PARKING BRAKE ADJUSTMENT

1.Disengage the PTO, stop the engine, block the front wheels, remove the ignition key, and engage the parking brake.

2.Locate the upper brake spring (A, Figure 34).

3.With the parking brake engaged, measure the com- pressed spring length. The spring should be

2” to 2-1/8” (5,0-5,4cm) when compressed.

4.If the spring is not within this range, jack up the rear of the machine and secure with jackstands. Remove both drive tires.

5.Locate the lower brake spring and adjustment clevis (A & B, Figure 35).

6.Release the parking brake and disconnect the clevis

(B) from the caliper lever (C). Turn the clevis to com- press or release the upper spring. Lock the nut against the clevis and reinstall the clevis onto the caliper lever.

CAUTION

Do not adjust the spring to be shorter than2” (5,0cm) when compressed. This may damage the brake caliper.If this does not correct the braking problem, see your Ferris dealer.

Troubleshooting, Adjustment & Service

FRONT2" - 2-1/8"

A

(5,0 - 5,4cm)

 

Figure 34. Parking Brake Adjustment

A.Upper Brake Spring

A

B

C

Figure 35. Parking Brake Adjustment

A.Lower Brake Spring

B.Adjustment Clevis

C.Caliper Lever

29