Troubleshooting
NEUTRAL ADJUSTMENT
If the tractor “creeps” while the ground speed control levers are locked in NEUTRAL, then it may be necessary to adjust the linkage rod.
NOTE: Perform this adjustment on a hard, level surface such as a concrete floor.
1. Disengage the PTO, engage the parking brake |
| |
and turn off the engine. | B | |
2. There are three nuts (B, Figure 33) on the linkage | ||
A | ||
rod. The first two are to be used together to turn | ||
the rod and the third (towards the front of the | Figure 33. Neutral Adjustment | |
machine) is used to lock the rod in place. Loosen | ||
the jam nut that locks against the ball joint (B, | (RH side shown) | |
Figure 33) and turn the linkage rod (A) to adjust. | A. Adjustment Linkage Rod | |
If the machine creeps forward, turn the rod | B. Nuts | |
| ||
CLOCKWISE (while standing at the rear of the |
| |
machine, facing forward), if the machine creeps |
| |
backward, turn the rod |
| |
3. Lock the jam nut (B) against the ball joint when |
| |
neutral is achieved. |
| |
NOTE: This adjustment should not be performed while | A | |
the machine is running. It may take several attempts | ||
to achieved neutral, depending upon how much the |
| |
machine creeps. |
|
|
| for |
| |
ADJUSTMENT |
| B | ||
|
| |||
To determine if it is necessary to adjust the neutral | Fig | re 34. Return to Neutral Adjustment | ||
return, perform the following steps. |
| |||
| A. Return Spring | |||
1. Disengage the PTO, engage the parking brake | ||||
B. Set Collar | ||||
and turn off the engine. | Not | |||
|
| |||
|
|
| ||
2. Move the ground speed control levers into the |
|
| ||
operating position, pull levers rearward and |
|
| ||
release. |
|
|
| |
3. Move the ground speed control lev rs out towards |
| |||
the neutral position. If the levers do not align |
|
| ||
with the notches in the neutral lock plate, it is |
|
| ||
necessary to adjust the neutral return rod. |
|
| ||
TO ADJUST: | Reproduction |
1.Loosen the set collar (B, Figure 34) locked against the return spring (A).
2.Lock the ground speed control levers in neutral.
3.Tighten set collar against the return spring.
4.Pull lever rearward and release to check that the lever stops aligned with notch in the neutral lock plate.
It is important to note that after every adjustment of the neutral return spring, the lever must be returned to locked position to properly check the neutral position.
36 | www.ferrisindustries.com |