![](/images/new-backgrounds/1107596/10759627x1.webp)
Operating the Dual Drive Walk-Behind
MOWING
Before mowing, set the cutting height as described in the Troubleshooting, Adjustments & Service section.
1.Engage the parking brake. Make sure the PTO switch is disengaged and the motion control lever is in the NEUTRAL position.
2.Start the engine (see STARTING THE ENGINE).
3.Set the throttle to FULL.
4.Engage the PTO by pulling up on the PTO switch (E, Figure 1).
5.Begin mowing. See Lawn Care section for tips on mowing patterns, lawn care, and trouble shooting information.
6.When finished, shut off the PTO.
7.Stop the engine (see STOPPING THE TRACTOR AND ENGINE).
PUSHING THE MOWER BY HAND
DO NOT TOW MACHINE
Towing the machine will cause hydraulic transaxle damage. Do not use another vehi- cle to push or pull this unit.
1.Disengage the PTO, engage the parking brake, turn the ignition OFF, and remove the key.
2.To disengage the transmissions
3.Disengage the parking brake.
The mower can now be pushed by hand.
4.After moving the mower,
A |
Figure 3. Hydraulic System By-Pass
A.Hydraulic Release Lever
12