![](/images/new-backgrounds/1107596/10759649x1.webp)
Shimming the Hanger Shafts
Once it has been determined that a shim (P/N 20928) is required, you first must determine which rear hanger shaft requires the shim.
The shim (A, Figure 20) must be placed in between the spacer (B, Figure 20) and the retaining collar (C, Figure
20)on the OPPOSITE side from which the front shaft has movement or slack (see Figure 21).
Once the shim has been assembled in the proper loca- tion, repeat Step 2 - 8 in the DECK LEVELING ADJUSTMENT section. This adjustment may need to be repeated more than once until the proper number of shims has been installed to obtain the proper cutting height, equal measurements from side to side and no movement of the front hanger shafts.
Troubleshooting, Adjustment & Service
B
A
C
Figure 20. Shim Assembly Position
A.Shim
B.Spacer
C.Retaining Collar
Figure 21. Proper Shim Location |
MOWING HEIGHT ADJUSTMENT
(DDSH Models only)
Refer to the Height Selection decal (A, Figure 22) locat- ed on the deck hanger frame and adjust the positions of the caster spacers and hairpins to obtain the desired mowing height. Perform adjustment to all four shafts.
CUTTING HEIGHT | C | ||
CASTER SPACER PLACEMENT | |||
2 |
| ||
| |||
3 |
| ||
| |||
4 |
| ||
| |||
|
| 46028 |
|
A |
|
| B |
|
|
|
Figure 22. Mowing Height Adjustment
A.Height Selection Decal
B.Caster Spacer
C.Hairpin Clip
23