Changing the clamping collet
11
– Push the machine downwards until the |
router bit rests on the surface (reference |
8.1
8.2
8.3
A
8.4
surface). Clamp the machine in this position |
by tightening the rotary knob [9.1]. |
– Press the depth stop [9.3] against one of |
the three fixed stops on the rotary stepped |
stop [9.4]. |
– Slide the indicator [9.5] down to the 0 mm |
mark on the scale [9.7]. |
Note:
–If necessary, slide the chip guard [8.2] upwards until it engages.
–Press the rocker [8.1] for the spindle lock to side A.
–Unscrew the locking nut [8.3] completely.
–Remove the locking nut from the spindle together with the clamping collet [8.4]. Do not separate the locking nut and clamping collet as these form a single component.
–Attach a new clamping collet with locking nut to the spindle.
–Screw on the locking nut loosely. Do not tighten the locking nut until a router bit is inserted.Adjusting the milling depth
Adjusting the milling depth
The milling depth is adjusted in two steps:
a) Setting the zero point
9
6 | 7 | 8 |
9.1 |
| |
|
| |
|
| 80 |
70 | 9.7 |
60 |
|
50 |
|
40 |
|
30 | 9.6 |
20 | |
0 | 9.5 |
10 |
|
9.2 | A |
9.3 | B |
9.4 | C |
|
–Place the router on an even surface (refer- ence surface).
–Open the clamping lever [9.2].
–Unscrew the rotary knob [9.1].
fIf the base position of the indicator is incor- rect, this can be adjusted by turning the screw [9.6] on the indicator.
The stepped stop [9.4] has three stops, two of which can be adjusted in height using a screwdriver:
•Stop A: 18 mm - 51 mm
•Stop B: 6 mm - 18 mm
•Stop C: 0 mm
Note:
fStop C has an offset for preliminary routing - see "Preliminary/Fine routing".
b) Presetting the routing depth
10.6 |
|
| 10.5 |
6 |
| 8 | 9 |
7 |
| ||
10.1 |
|
| |
|
|
| |
|
| 80 |
|
|
| 70 |
|
|
| 60 |
|
|
| 50 | 10.8 |
10.2 |
| 40 | |
| 30 |
| |
|
|
| |
|
| 20 |
|
|
| 10 |
|
|
| 0 | 10.7 |
10.3 |
|
| |
|
|
| |
10.4 |
|
|
|
–Pull the depth stop [10.4] upwards until the indicator [10.2] reaches the required routing depth.
–Clamp the depth stop in this position using the clamp lever [10.3].
–Unscrew the rotary knob [10.1]. The ma- chine is now in starting position.
–If necessary, you can readjust the rout- ing depth by turning the adjusting wheel
