Wall mounting LC 45
The charger LC 45 has two longitudinal slots on its rear by which it can be suspended on walls using two screws (e.g.
Machine settings
Exchanging the battery pack
-Removing battery pack: Press the two buttons (1.6) and slide the battery pack forwards to remove.
-Inserting battery pack: Slide the battery pack into the holder on the underside of the handle until it latches into place (1.7).
To change the direction of rotation
The selector button (1.2) determines the direction of rotation.
•Turn button from right to left = clockwise rotation.
•Turn button from left to right = anticlockwise rotation.
•Selector button in central position = circuit interlock.
Shifting speeds
Change only when completely
stopped!
Using the shift lever (1.3), the speed can be changed.
•1. Speed: Lever forward - Figure 1 is visible.
•2. Speed: Lever backwards - Figure 2 is visible.
Torque adjustment
By turning the adjustment ring (1.4) the required torque can be adjusted. The arrow (1.5) aligns with the adjusted state.
Drilling:
Drilling symbol on adjustment ring aligns with the arrow = maximum torque.
Screwing:
Torque corresponding to setting:
•Position 1 = low torque
•Position 20 = high torque
Operation
Turn on by pressing button (1.1). Depending on the pressure exerted on the button, the adjust- ment of running speed can be varied infinitely.
Turn off by releasing the button (1.1). After releasing the button, the chuck is stopped and therefore,
Tool holding fixture, attachments
Make sure that the machine is switched of and the battery block has been removed before changing the tool holding fixture, attachments and tools.
Chuck BF-FX
The chuck is used to clamp drills and bits.
Fitting:
-Place the chuck on the drill spindle (2.5) and twist until the hexagon key (2.4) of the chuck latches into the hexagon socket of the drill spindle.
4
