Field Controls specifications Power Venter System, Model PVO-300, PVO-600

POWER VENTER SYSTEM

Model: PVO-300, PVO-600

Included is one ETL and cETL listed Power Venter to be used primarily with a single 120VAC controlled oil fired furnace, boiler, or water heater. The PVO may be used to common vent multiple appliances with the addition of a Control Kit. Please consult Field Control’s Technical Support for other options.

TYPICAL VENTING SYSTEM COMPONENTS

One PVO Series Power Venter with pre-wired controls; adjustable post purge relay timer, adjustable draft proving switch, direct access terminal blocks, and piping tee for multiple appliance systems.

• Side Wall Vent Hood (Not included)	• Spill Switches (Not included)
• CK-Series Control Kit for multiple appliance venting (Not Included)
CONTENTS	PAGE
Unit Specifications	2
System Operation	2
Power Venter Sizing	3
Installation Safety Instructions	4
Installation of Power Venter	5
General Wiring Instructions	5-6
Airflow Adjustments	7
Pressure Switch Adjustments	7
Post Purge Timer Adjustments	7
Multiple Appliance Systems	7
General Installation Inspection	8
Maintenance	8
Replacement Parts List	9
Venting System Operational Information	10
Installation Information	10

This device MUST be installed by a qualified agency in accordance with the manufacturers installation instructions.

The definition of a qualified agency is: any individual, firm, corporation or company which either in person or through a representative is engaged in, and is responsible for, the installation and operation of gas appliances, who is experienced in such work, familiar with all the precautions required, and has complied with the requirements of the authority having jurisdiction.

DO NOT DESTROY

THESE INSTRUCTIONS MUST REMAIN WITH EQUIPMENT

2630 Airport Road · Kinston, NC 28504

Phone: 252-522-3031· Fax: 252-522-0214

www.fieldcontrols.com