3.Drill a 1/8” hole into the body of the
4.Secure the extension covers the
5.Remove the two rubber feet on the side of the extension cover from bottom of unit to give necessary clearance for ceiling mount. (See Figure 11)
Figure 8
|
|
| Figure 11 |
Figure 9 | Figure 10 |
|
6.Before hard wiring the
7.Mount the supplied electrical conduit box over the power wires and secure with the supplied mounting screws. (See Figure 13)
Figure 12
Figure 13
8.Locate and remove the ceiling tile where the
9.Install eyelet screws or other appropriate anchors into the ceiling joists above the location where the will be installed. If installing the
10.Install the
Figure 14
Support Wire
Figure 15
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the