8. Insert lamp through hole until lamp cannot be inserted any further. (See Figure 16)
9.Swing swivel bracket over end of lamp.
10.Plug ballast plug into end of lamp. (See Figure 18)
Figure 16
Figure 17
Figure 18
11.Replace cover on unit. Tighten side screws. (See Figure 19 & 20)
12.Plug the power cord into a standard electrical outlet.
NOTE: Seal the joints and seams of the plenum near the mounting location to reduce any direct viewing of light. (See Figure 1)
|
|
Figure 19 | Figure 20 |
13.Flip switch on box to the ‘ON’ position. (Light on switch should be on indicating power.)
14.Look through view port in the box cover to be sure lamp is working. You should see a blue glow. (The view port is covered with a plastic lens that blocks the UVC rays.)
15.If the lamp is not glowing, follow steps
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the
Page 5
