FieldServer FS-8700-103 instruction manual Word baudRate =

FS-8700-103_ATMI_TGM_Serial Manual Page 27 of 28

Appendix D. Troubleshooting tips

Appendix D.1. Connection Tips & Hints

The ATMI-TGM’s serial ports are configured using the TGM’s configuration file – typically named config.dat

Search for the following section. The port you wish to connect to must be set as a “Remote Console”.

/* the channel utilization array specifies how a parallel (or serial) */

/* channel is to be utilized. The possible entries are:			*/
/*	0	= this channel is forced out of service (not implemented, etc)*/
/*	1	= this channel is a printer device	*/
/*	2	= this channel is a remote console	*/

/* There can be more than one printer device (max = all 3 channels), */

/* but there can be only one remote console (COM1: or COM2 :).			*/
/* Leave the Acoustic Sensor entry = 0 (controlled by bvCous)			*/ /* PMC */
BYTE chanUtil[] = {
0,	// [0] = local (parallel) printer
0,	// [1]	= COM1: serial channel
2,	// [2]	= COM2: serial channel
0,	// [3]	= Acoustic Sensor serial channel
};

/* the baudRate table specifies the baud rate for the serial channels */

/* can be one of: 110, 300, 600, 1200, 2400, 4800, 9600, 19200, 38400 */

/* an entry of 0 in chanUtil[] overrides the entry here			*/ /* PMC, too slow and wont finish printing in time
*/
WORD baudRate[] =		{
XX,	// [0]
9600,	// [1]	// COM1:
9600,	// [2]	// COM2:
9600,	// [3]	// cous chan
};

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com