FieldServer FS-8700-132, FCI E3 Series instruction manual

FS-8700-132 Gamewell FCI-E3 Driver Manual		Page 18 of 20
	Message	Description
		This message should only be printed if a
	FCI_E3:#17 Err. Loop=%d < 1. Rejected. , drv_bd->loop )	byte in a message has been corrupted. If
		you notice it more than once then take a
		log and contact tech support.
		If this error is repeated often it is possible
	FCI_E3:#18 Err. Loop Type='%c'(%#x) Not recognized. ,	that a FCI firmware update has made the
	drv_bd->point_identifier[2] , drv_bd->point_identifier[2] )	driver unusable. Take a log and contact
		tech support.
	FCI_E3:#19 Err. Relay=%d < 1. Rejected. , drv_bd->relay	This message should only be printed if a
		byte in a message has been corrupted. If
	FCI_E3:#20 Err. Zone=%d < 1. Rejected. , drv_bd->zone"	you notice it more than once then take a
		log and contact tech support.
	FCI_E3:#21 Err. Point Type not recognized	Valid Point Types are listed in section
	FCI_E3:#22 Err. Undefined Point Type"	4.4.25
	FCI_E3:#23 Err. Event Type not recognized	Valid Event Types are listed in section
	FCI_E3:#24 Err. Undefined Event Type	4.4.25
	FCI_E3:#25a Err. Address+Length>99. Length Truncated	The maximum value for a sensor/module
	FCI_E3:#25b Err. Address+Length>99. Length Truncated	is 99. The combination of address and
		length specified produce a number > 995
	FCI_E3:#26 Err. Invalid Module number. Expected 1..99
	FCI_E3:#27a Err. Invalid Loop number. Expected 1..10
	FCI_E3:#27b Err. Invalid Loop number. Expected 1..10
	FCI_E3:#27c Err. Invalid Loop number. Expected 1..10	Correct the configuration file5
	FCI_E3:#28 Err. Invalid Sensor number. Expected 1..99
	FCI_E3:#29 Err. Invalid Zone number. Expected 1..255
	FCI_E3:#30 Err. Invalid Relay number. Expected 1..255
	FCI_E3:#31 Err. Point Type Invalid.	Valid Point Types are listed in Section
		4.4.25
	FCI_E3:#32 Err. No MD Length. Default to 1	The length of each Map Descriptor should
		be specified. Refer to Section 4.4.25
		The driver can only listen passively for
	FCI_E3:#33 Err. Driver can’t poll or write.	message from the panel. Map Descriptors
		may not be configured as active. 5
		An event message is less than 80 bytes
		long. If this error is repeated often it is
	FCI_E3:#36 Err. Too Short. Bytes=%d , conn->ux_iptr"	possible that a FCI firmware update has
		made the driver unusable. Take a log and
		contact tech support.

5Correct the configuration file, download to the FieldServer and restart the FieldServer for the changes to take effect.

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com