FieldServer FS-8700-43 instruction manual Driver Related Map Descriptor Parameters

FS-8700-43 VESDA Driver Manual Page 8 of 18

4.4.Client Side Map Descriptors

4.4.1.FieldServer Related Map Descriptor Parameters

Column Title	Function	Legal Values
Map_Descriptor_Name	Name of this Map Descriptor	Up to 32 alphanumeric
		characters
	Name of Data Array where	One of the Data Array
Data_Array_Name	data is to be stored in the	names from “Data Array”
	FieldServer. Only used for	section above. Must be of
	commands 1,4,6,12.	type BIT
Data_Array_Location	Starting location in Data Array	0 to maximum specified in
		“Data Array” section above
	Function of Client Map
Function	Descriptor. A Command is a	RDBC, WRBC, WRBX
	write, and a response is a read

4.4.2.		Driver Related Map Descriptor Parameters
	Column Title		Function	Legal Values
				One of the node names
	Node_Name		Name of Node to fetch data from	specified in “Client Node
				Descriptor” above
	Data_Type		Data type	Dig_input or dig_output
	Length		Length of Map Descriptor	1 to end of data block or less
	Address		Starting address of read block	The start bit number of the data
				of interest
	Command		The command id as given in the	1,4,6,10,12,16
			notes.
	Network		The network number	1-255
	Zone		The zone number	1-255 or 0 if the Zone is not
				configured on the Panel
	Sector		The sector number	1-255 or 0 to read the average
				smoke level and highest alarms.
			Name of Data Array where data	One of the Data Array names
	DA_Bit_Name		is to be stored in the FieldServer.	from “Data Array” section above.
			Used for command 10 and 16.	Must be of type BIT
	DA_Bit_offset		Starting location in Data Array.	0 to maximum specified in “Data
			Used for command 10 and 16	Array” section above
			Name of Data Array where data	One of the Data Array names
	DA_Float_Name		is to be stored in the FieldServer.	from “Data Array” section above.
			Only used for command 10.	Must be of type FLOAT
	DA_Float_offset		Starting location in Data Array.	0 to maximum specified in “Data
			Only used for command 10	Array” section above
			Name of Data Array where data	One of the Data Array names
	DA_Byte_Name		is to be stored in the FieldServer.	from “Data Array” section above.
			Only used for command 16.	Must be of type BYTE
	DA_Byte_offset		Starting location in Data Array.	0 to maximum specified in “Data
			Only used for command 16	Array” section above

FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com