Fiesta Products 7305 manual ESC Profile Selection, ESC Profile Description

Solid Green

Release

Two blinks Red

Green to Red to Off

Solid Green

Release

One blink Red

Green to Red to Off

Release

Solid Green

Green to Red to Off Three blinks Red

ESC Profile Selection

The speed control is factory set to Profile #1. To change the profile, follow the steps on described below. The speed control should be connected to the receiver and battery, and the transmitter should be adjusted as described previously. The profiles are selected by entering the programming mode.

ESC Profile Description

Profile #1 (Sport Mode): 100% Forward, 100% Brakes, 100% Reverse

Profile #2 (Race Mode): 100% Forward, 100% Brakes, No Reverse

Profile #3 (Training Mode): 50% Forward, 100% Brakes, 50% Reverse

Selecting Sport Mode (Profile #1)

1. Turn on your transmitter and connect a fully charged battery pack to the ESC.

2. With the ESC off, press and hold the EZ-Set button until the light turns solid green,

then solid red and then begins blinking red (indicating the

Profile numbers).

3.When the light blinks red once, release the EZ-Set button.

4.The light will then turn green and the model is ready to drive.

Selecting Race Mode (Profile #2)

1. Turn on your transmitter and connect a fully charged battery pack to the ESC.

2. With the ESC off, press and hold the EZ-Set button until the light turns solid green,

then solid red and then begins blinking red (indicating the

Profile numbers).

3.When the light blinks red twice, release the EZ-Set button.

4.The light will then turn green and the model is ready to drive.

ADJUSTING THE ELECTRONIC SPEED CONTROL

Selecting Training Mode* (Profile #3)

1. Turn on your transmitter and connect a fully charged battery pack to the ESC.

2. With the ESC off, press and hold the EZ-Set button until the light turns solid green, then solid red

and then begins blinking red (indicating the Profile numbers).

3. When the light blinks red three times, release the EZ-Set button.

4. The light will then turn green and the model is ready to drive.

Note: If you missed the mode you wanted, keep the EZ-Set button pressed down and the blink cycle will repeat until a Mode is selected.

Patent Pending Training Mode (Profile #3) reduces forward and reverse throttle by 50%. Training Mode

is provided to reduce the power output allowing beginning drivers to better control the model. As driving skills improve, simply change to Sport or Race Mode for full-power operation.

Tip For Fast Mode Changes The ESC is set to Profile 1 (Sport Mode) as the default. To quickly change to Profile 3 (Training Mode), with the transmitter on and the ESC turned off, press and hold the SET button until the light blinks red three times and then release. For full power, turn off the ESC then quickly change back to Profile 1 (Sport Mode) by pressing and holding the SET button until the light blinks red one time and then releasing.

*Patent-pending

TRAXXAS • 15