DRIVING YOUR MODEL
•Transmission: Remove, disassemble, and clean the transmission components. No grease is required for the nylon gears. Refer to your exploded view diagrams for help with disassembly and reassembly.
•Motor: Remove the motor, clean with aerosol motor cleaner, and re-
oil the bushings with lightweight motor oil. Be sure to wear eye protection when using spray aerosol cleaners.
RECEIVER BOX: MAINTAINING A WATERTIGHT SEAL
Removing and Installing Radio Gear
The unique design of the receiver box allows the removal and installation of the receiver without losing the ability to maintain a watertight seal in the box. The
Removing the Receiver
1.Remove the 2.5x8mm screws that secure the wire clamp.
2.Remove the 2.5x8mm screws that secure the receiver box lid to the chassis. Lift the lid up and toward you to disengage the lid’s tab from its slot in the chassis.
3.You can now access the receiver. Unplug the servo cables from the receiver and remove the receiver.
Receiver Installation | A | B |
1.Route the antenna wire out of the receiver box cover (A). Place the
| cover on the chassis. |
|
| |
2. | Route the servo and |
|
|
|
|
|
| ||
| speed control leads into the receiver box |
| C | |
|
|
| ||
| cover. Use the |
|
| |
| align the servo and speed control leads and |
|
| |
| antenna wire (B). |
|
| |
|
| D | ||
3. | Apply a small bead of silicone grease |
| ||
|
| |||
| (Traxxas part #1647) to the wire clamp (C). |
|
| |
4. | Install the wire clamp and tighten the two |
|
| |
| 2.5x8mm screws securely (D). |
|
| |
|
|
|
|
|
18 • TRAXXAS
5.Lift the receiver box cover and plug the servo and speed control leads into the receiver (E). Refer to page 8 for the wiring diagram.
6.Bundle the wires so they fit beneath the receiver box cover. You may secure the receiver to the chassis with mounting tape if you wish, but this is not required. The excess wire beneath the cover will prevent the receiver from rattling.
7.Make sure the blue
8.Inspect the cover to make sure the
E
F
G