INSTALLING THE SIDEBURNER SHELF

 

 

Screw Air

Shelf

 

Hole

shutter

 

Brass

 

 

 

 

 

 

oriÞ ce

 

Fig. 15-1

 

 

 

 

 

Air-shutter oriÞ ce placement - under shelf

 

 

 

Male

Female

Fig. 15-2

Connecting the ignitor wires

Cap

Fig. 15-3

Placing the burner cap

Lid

Grate

This shelf comes separate from the grill for convenience in shipping. The sideburner shelf must be installed using the following instructions before hooking up the grill to a gas source.

INSTALLING THE SIDEBURNER SHELF

1.Remove the protective plastic from the grill, sideburner, and sideburner lids by carefully peeling it off with your fingers. Do not use tools.

2.Hold the sideburner shelf up against the left side wall of the grill so that the holes in the shelf line up with the four (4) threaded screw holes in the side wall and the air-shutter end of the sideburner venturi tube Þ ts around the brass oriÞ ce protruding from the side of the cart.

WARNING: It is critical for safety and for the proper function of the sideburner that the sideburner venturi tube with air shutter be centered around and completely cover the gas oriÞ ce.

3.Insert and start screws with Þ ngers and then tighten using a nut driver, wrench, or ratchet.

Note: Upon completion, the air shutter must still

Þt around the brass oriÞ ce.

4.Connect the female connectors on the ends of the hot surface ignitor wires to the male connectors coming from inside the grill.

5.Place the burner cap on top of the burner, as shown in Fig. 15-3.

6.Place the grid so that it rests on the front and back lips of the sideburner opening (Fig. 15-4).

7.Proceed to the section on AIR SHUTTER ADJUSTMENT and complete the installation by adjusting the air shutter. This will also test the sideburner installation.

Fig. 15-4

Final look

15