OPTIONAL POWERHOOD

The Fire Magic¨ Power Hood is available only as an Echelon E1060 factory shipped option. Read the following before using the grill.

Important: Grill must be connected to electrical power to open and close lid by motor.

OPENING AND CLOSING THE LID BY REMOTE OR CONTROL PANEL ROCKER SWITCH

Note: See below for manual operation procedure.

While set up for motorized opening and closing, the lid may be controlled either by the black rocker switch on the right side of the control panel or by the remote control included with units conÞ gured with the motorized lid option.

The rocker switch will lock in any one of three positions: upÐcommanding the lid to open, down Ðcommanding the lid to close, and centerÐallowing the lid to hold its current position and respond to remote control.

For safety reasons, the rocker switch on the control panel will always override the remote control.

To enable remote control of the lid, set the rocker switch to center.

To open the lid, press and hold the open button on the remote until the lid reaches the desired location. Then release the remote buttons, and the lid will stay in place.

To close the lid, press and hold the close button on the remote until the lid reaches the desired location. Then release the remote buttons, and the lid will stay in place.

If the rocker switch is left in the down position, remote up commands will affect the lid only as long as the remote button is held. When released, the motor will move the lid back to the closed state. With the rocker switch in the up position, the remote has no effect.

Fig. 17-1

Fig. 17-2

UP

DOWN

CONFIGURING THE LID FOR MANUAL OPENING AND CLOSING

WARNING

If the grill has been on recently, all Power Hood components are potentially hot. Wait for grill to cool before beginning this procedure or wear heat-resistant gloves.

CAUTION: Do not push or pull on the lid or its handle while it is configured for automatic operation. This could result in damage to the grill.

To conÞ gure the lid for manual opening and closing, simply remove the locking bolt using the following procedure. This procedure requires the use of the Allen wrench supplied with this option.

1.Open the lid completely, then set the rocker switch to the center position and disconnect electrical power to the unit.

2.Use a Phillips screwdriver to remove the stainless- steel motor assembly housing screw. Pull the top of the housing Þ rst up and then outward away from the lid until the top of the shroud clears the lip of the motor mount beneath, then remove the housing completely and set it aside (Fig. 17-3).

3.Use the Allen wrench to loosen and remove the lid motor assembly locking bolt and washer (see next page).

Important: Keep this bolt and washer for later use in converting the unit back to automatic lid operation.

4.Replace the motor assembly housing and refasten.

Fig. 17-3

Gear cover plate

Motor assembly housing

17