INSTALLATION
CAMERAS & WIRELESS RECEIVER 4
INSTALLING CAMERAS
1.Select the position for the camera and secure the camera stand. (Screws and anchors are supplied. Use an appropriate screw type for the mounting surface.)
2.Screw the camera onto the bracket.
3.Adjust camera to the proper view angle Make sure the lens is upright relative to your subject. Tighten the thumb bolt.
4.Screw the antenna into place on the rear of
the camera. Adjust the antenna to an upright position.
5. Connect the power cable to the DC IN of the camera.
6. Plug the power supply into the electrical outlet.
7.Once the camera is connected, see Camera Setup, Camera Pairing to link the camera(s) to the receiver.
Camera Orientation
It’s important the camera is mounted correctly to ensure the image is not upside down as the camera lens can only be positioned one way.
SETTING UP THE WIRELESS RECEIVER
1.Connect the power cable to the DC IN of the receiver.
2.Plug the power supply into the electrical outlet.
3.Once the receiver is connected, see Camera Setup, Pairing (Operating Menus) to link the camera(s) to the receiver.
OPTIONAL: VIEW ON TELEVISION OR OTHER MONITOR
1.If connecting to another monitor such as a TV: Connect the AV cable into the AV OUT of the receiver.
2.Connect the two RCA jacks to the TV
AV IN. Yellow = Video; White = Audio
3. Press POWER button to turn on the | Audio |
| |
receiver. | Video |
Rechargeable Battery
Caution: The 7” monitor is fitted a 3.7V 2000mAH
Check with your local authority or retailer for recycling advise.
TV
Page 9