86(5)81&7,216
Message Recording/Playback/Volume Control
Recording a Message
Your system can record a brief message (up to 20 seconds) that can be played back later.
To record a message:
FUNCTION
+
RECORD
The keypad beeps and displays “REC MESSAGE.” Begin speaking into the microphone.
NOTE: The Record function can only be performed from the master keypad. It cannot be performed from any other wireless keypad (ex. 5827BD, 5827).
To stop recording before the end of 20 seconds: Press OFF
Otherwise, the recording automatically stops after 20 seconds. The keypad beeps twice, the REC display turns off, but the MESSAGE display remains on.
Message Playback
The lighted word MESSAGE indicates that a new message is in memory. After playing the message, the MESSAGE display turns off. See NOTE below if using a wireless keypad.
To play back a message:
FUNCTION
+
PLAY
Adjusting the Volume
The volume level of message playback, system announcements, and status beeps can be changed. You can also mute system announcements if desired. See NOTE below if using a wireless keypad.
To adjust message playback/system announcemnt volume:
FUNCTION
+
VOLUME
+ [3] or [6] where: [3] = increases volume one level,
[6] = decreases volume one level (The keys beep at the selected volume when pressed.)
Repeat the key sequence until the desired volume level is achieved.
To mute system announcements: FUNCTION + VOLUME +
OFF
When muted, no system announcements will be made. Recorded messages will be
announced, though, when PLAY is pressed.
To restore announcement sounding:
FUNCTION
+
VOLUME
+ [3] or [6]
Volume level will be restored to the level that was selected prior to muting the sound.
NOTE: If a wireless keypad (5827/5827BD) has been installed and is programmed for quick arming, it cannot be used to activate message playback or adjust the volume. In this case, you must use the master keypad to perform these functions.
