MOUNTING THE SPREADER
SWING AWAY® Spreader
CAUTIO | N |
WARNING
CAUTION
CAUTION
During removal or mounting, securely grip spreader to avoid dropping.
NOTE: The spreader shall be installed according to instructions supplied. Your local outlet is trained to provide this service and service your spreader with factory original parts.
1.Fasten the left and right top brackets along with any shims to the truck bed rail with two 1/2" cap screws, two 1/2" flat washers and two 1/2" locknuts per bracket. Install the two 5/16" cap screws and locknuts to the side of the top brackets.
2.Place the left and right base plates on the bumper of the truck and line up with the holes in the bumper.
3.Attach the base plates to the bumper using three 3/8" cap screws, three 3/8" plain washers, any shims and three 3/8" locknuts per side.
4.Place the spreader on the base plates and insert the hinge pins. Secure the hinge side by installing one 1/4" cap screw and 1/4" locknut through the hole in the base plate boss and hinge pin.
5.Install hitch pin clip through the base plate boss and the removable hinge pin.
6.Plug the spreader harness into the vehicle harness.
7.Plug the stoplight cord into the vehicle stoplight harness.
Receiver Mount Spreader
WARNING
CAUTION
CAUTION
During removal or mounting, securely grip spreader to avoid dropping.
NOTE: The spreader shall be installed according to instructions supplied. Your local outlet is trained to provide this service and service your spreader with factory original parts.
1.Attach the spreader to the receiver mount with six
2.Insert the assembled unit into the receiver hitch and secure with pin (not included).
3.Plug the spreader harness into the vehicle harness.
April 1, 2005 | 8 | Lit. No. 94430/94431 |
