Oven and Oven Runners
Clean the inside of the oven while still warm, using household detergents or an ammonia based cleaner, e.g. Handy Andy. "Off the shelf" oven cleaners may be used providing the instructions supplied by the manufacturer are followed carefully. Do not use oven cleaner on self cleaning liners. The wire side runners may be removed to make cleaning easier.
To remove the runners:
•
•
•
Gently push the retaining wire underneath the stud down then lift the runners up and towards the centre of the oven. The prongs at the top will slide out.
To replace the runners, hold the runner and push prongs fully into small slots at top of oven cavity.
Lower runners and gently place retaining wire underneath the stud.
Warning
Do not lower runners until prongs are fully inserted.
Self Cleaning Liners
Self cleaning liners are fitted in some models of
Self cleaning liners are fitted to the side walls and back of the oven. The liners are coated with a special enamel which is porous and contains oxidising catalysts.
Any grease and dirt coming into contact with the liner is absorbed by the enamel and is broken down with the help of the oxidising catalysts at normal cooking temperatures.
As cleaning is improved by using a high temperature, it may be necessary to run the oven at Fan Grill, maximum temperature for one or two hours if needed.
The oven roof is self cleaning as the heat from the grill element will break down grease and dirt which may be deposited.
Warning
Do not use any detergent, abrasives or oven cleaners on self cleaning liners.
Fat Filter
The fat filter should be cleaned after every use. For normal soiling, place in a dishwasher on normal wash. If the fat filter is very dirty, place in a saucepan with either 2 tablespoons of washing powder, or 1 tablespoon of dishwasher powder. Bring to the boil and leave to soak for at least 30 minutes. Rinse the filter in clean water and dry.
27
