2PRODUCT & CABINETRY DIMENSIONS
3CLEARANCE DIMENSIONS
Note: Gas inlet connection is |
|
| |
located in the back left corner. | K |
| |
|
|
| |
|
| L | G* |
|
| B | |
D | C |
| |
|
| ||
|
|
|
E F A
J
I
H
Installation diagrams for illustration purposes only
C
E
D
A
F B
G
WARNING!
The CookSurface requires adequate air supply to fully function. The base of the CookSurface must have direct unrestricted ventilation to the room where the CookSurface is installed. Do not ventilate the base area to an external area that can be at dierent air pressure to that of the burners. You may ventilate from adjacent cupboards, but ensure that the available air supply will not be restricted. The ventilation area must be 500 x 50 mm or of an equivalent area. If the 50 mm wide slot is not possible due to the width of the available toe recess, increase the length of the slot so as to maintain
An air intake grill is provided. Ensure that the grill is not covered or obstructed. Flush
Product and cabinetry dimensions (mm)
|
|
| CG903ML IZ ONA | CG903MLD EIZONA D EP |
|
|
|
| |
A | overall height of product (including retracted dials/pan supports) | 96 | 96 | |
B | overall width of product |
| 900 | 900 |
C | overall depth of product |
| 410 | 530 |
D | height of chassis (below top of bench) | 89 | 89 | |
E | width of chassis |
| 856 | 856 |
F | depth of chassis |
| 384 | 480 |
G | depth of chassis | tted elbow*) | 424 | 480 |
H | overall width of cutout |
| 865 | 865 |
I | overall depth of cutout |
| 390 | 494 |
J | corner radius of cutout |
| max. 10 | max. 10 |
K | distance from top of bench to centre of gas inlet on product | 64 | 64 | |
L | distance from edge of chassis to gas inlet on product | 20 | 20 |
Clearances (mm) | CG903ML IZONA | CG903MLD ONA DEEP | |
|
|
| IZ |
|
|
| |
A minimum clearance from left edge of product to nearest combustible surface | 60 | 60 | |
B minimum clearance from right edge of product to nearest combustible surface | 80 | 80 | |
C | minimum clearance from rear edge of product to: |
|
|
nearest combustible surface | 100 | 10 | |
| nearest | 10 | 10 |
D minimum height of | 150 | 150 | |
| minimum clearance from glass surface to: |
|
|
E | rangehood | 650 | 650 |
any other overhead exhaust fan | 800 | 800 | |
| downward facing combustible surface | 650 | 650 |
| re resistant surface | 500 | 500 |
F | minimum clearance below top of benchtop to: |
|
|
combustible surface | 115 | 115 | |
| Fisher & Paykel oven or nearest | 100 | 100 |
Gcutout measuring 50 x 500 mm for air intake grill. Ensure air can easily enter the area around the base of the product from the room in which the product is installed
Note: *(CG903ML models only) If benchtop thickness exceeds 50 mm, additional cutout space will be required to tted elbow.
exible
hose must be used between the product gas inlet and the connector on the wall which should be 650 - 750 mm above oor and towards the