|
| Troubleshooting | 25 |
|
|
| |
Problem | Possible Cause | What to do | |
|
|
| |
Continuous | A fault has occurred. | Refer to the Fault codes section. | |
beeping |
|
|
|
|
|
|
|
US CA
Intermittent | DishDrawer® is in pause | Close the DishDrawer® and press the |
|
|
beeping | mode. | button. |
|
|
| ||||
|
|
|
|
|
DishDrawer® will | Power supply is not | Connect the power supply. | ||
not start | connected. |
|
|
|
|
|
|
|
|
The drawer is not closed properly.
Ensure the drawer is firmly closed.
| Lock feature is on. | Turn Lock off. Hold down the button until | |||
|
|
|
| the light above the button disappears. | |
|
|
|
|
| |
|
|
| button not pressed. | Press the button. | |
|
|
|
|
| |
Excess water in the | Drain hose(s) bent or | Straighten the drain hose(s). | |||
DishDrawer® | kinked. |
| |||
|
|
|
|
| |
| Blocked filters. | Clean the filter plate/drain filter. Refer to the | |||
|
|
|
| Care and cleaning section. | |
|
|
|
|
| |
Water marks on the | Rinse agent depleted. | Refill the rinse agent dispenser. | |||
dishes |
|
|
|
| |
Rinse agent setting too low. Increase the rinse agent setting. | |||||
| |||||
|
|
|
|
| |
| DishDrawer® overloaded/ | Refer to the section on loading. | |||
| incorrectly loaded. |
| |||
|
|
|
|
| |
DishDrawer® | Some foods, like tomato | ||||
interior is stained | based products, may | DishDrawer®. Alternatively, using the Rinse | |||
| stain the inside of the | program after adding the dishes may | |||
| DishDrawer®. | minimize staining. | |||
|
|
|
|
| |
Dishes did not dry | Incorrect loading. | Ensure the dishes are not nesting together. | |||
|
|
|
|
| |
| Rinse agent depleted. | Refill the rinse agent dispenser. | |||
|
|
|
|
| |
| Rinse agent setting too low. | Increase the rinse agent setting. | |||
|
|
|
|
| |
| Eco wash program used. | Choose a standard wash program. | |||
No detergent | Detergent dispenser was | Clean the dispenser and ensure the | |||
dispensed | wet when loaded. | dispenser is dry when adding detergent. | |||
|
|
|
|
| |
Excessive motor | The filter plate and/or spray | Refer to the care and cleaning section for | |||
noise | arm is incorrectly placed. | details on correct placement. | |||
|
|
|
|
| |
| No water in the motor area. | This usually occurs on the first use or when | |||
|
|
|
| the DishDrawer® has not been used for | |
|
|
|
| long periods of time. Run the DishDrawer® | |
|
|
|
| through a wash program. | |
