slot and ‘B’ bracket must match ‘B’ slot.
9 MOVE INTO THE CAVITY
2
1
2 
Ensure hoses and cord are not kinked or twisted.
10 SECURE THE DRAWER
3 
9SECURE THE DRAWER
The product has three pairs of fixing points:
(Refer to 4 for relevant parts)
Ensure the sound insulation is repositioned correctly.
a pair of fixing holes either side on the | 1 |
bottom |
|
(use 1½” (38 mm) fixing screws & washers) |
|
10REFIT THE DRAWER
2
two pairs of formed 
2brackets on either side of the chassis
(use 5⁄8” (16 mm) screws)
1
Open the drawer halfway. Using a
Using a small Philips screwdriver, screw through the trim moulding, securing the side mounting bracket to the cabinetry. Do not damage the rubber trimseal.
2 
3 
Replace the plastic gray plug back into the trim moulding and ensure the trimseal is facing forward.
|
|
| the | drawer | clips |
| |
|
|
|
|
| |||
|
|
| mm) |
| |||
|
| forward |
|
| |||
Pull | 13⁄16”(30 |
| Ensure the drawer is | ||||
| sides |
| |||||
on | both |
|
|
| |||
|
|
|
| now rotated | |||
|
|
|
|
|
| ||
clockwise back.
5 | 4 |
Ensure the drawer clips on | 1 |
both sides click into place. |
|
3
Before refitting the drawer, ensure the hoses are not twisted and the latches at the rear of each drawer runner are facing forward.
Repeat for all four brackets.
2
