6.4Detergent Dispenser
6.4.1Remove the drawer front and handle as per instructions in 6.1.& 6.2
6.4.2Disconnect the two wiring loom connections off the dispenser coils. Note: Push back locking tabs to allow connectors to release.
6.4.3Unclip the retainer flap at the bottom center of the dispenser and slide out the rinse aid level LED.
6.4.4Unclip the fill hose on the dispenser
6.4.5While holding the dispenser unscrew the six T10 Torx drive screws securing the brackets around the dispenser.
6.4.6The dispenser can now be removed from inside the tub.
6.4.7The coils can be replaced as a spare part by sliding them off the armature.
6.4.8To open up the dispenser door fully, first open the door using the release catch then squeeze the top sides of the door. This will release the door to the fully open position. This can be done with the dispenser in place.
6.4.9Refit in reverse manner ensuring the dispenser gasket is located correctly.
6.5Electronic Controller
6.5.1Remove the drawer front and handle as per instructions in 6.1.& 6.2.
6.5.2Placing a finger either side of the top sides of the controller, pull it forward until the controller clears the top edge of the tub.
6.5.3Disconnect the wiring connectors down the left side of the controller.
6.5.4The controller can now be tipped down to 90° from it’s original position. This will allow the disconnection off the lower wiring connectors and the two and three wire looms from their wire duct.
6.5.6The controller can now be lifted clear.
6.5.7Refit in reverse manner.
6.6Top Kick Strip Removal
6.6.1Pull out the lower drawer.
6.6.2Place both hands under the top kick strip.
6.6.3Pull the bottom of the top kickstrip forward quickly.
6.6.4Tipping it right up will allow the top locating tabs to drop out of the tub inserts.
6.6.5Refit in reverse manner ensuring it is clipped into place.
- 35 -
