USING THE HEATER
LIGHTING INSTRUCTIONS
TO LIGHT HEATER
Upon installation of the heater and completion of the gas line and electrical supply to each heater, follow the steps below for Lighting Instructions. Lighting instructions are also provided on the control panel of the heater.
Turn gas and power to “ON”. The burner should light within the first 4 seconds. If not, the flame sensor will shut off the
TO START HEATER
1.Turn manual gas valve to “ON” position.
2. Turn electrical supply “ON”.
TO SHUT DOWN HEATER
1.Turn electrical supply “OFF”.
2.Turn manual gas valve to “OFF” position.
WARNING!
If burner fails to ignite, shut down electrical power and wait 5 minutes before turning power “ON” to allow any gas to dissipate.
A remote control accessory
WARNING!
Do not attempt to light this heater by hand.
14