![](/images/new-backgrounds/1076501/7650131x1.webp)
EN
14
Using the appliance for the first time
Coffee has been used to factory test the appliance and it is therefore completely normal for there to be traces of coffee in the mill.
Customise water hardness as soon as possible following the instructions in section ‘Changing and setting menu parameters’, under “Setting water hardness”.
1Connect the appliance to the mains supply. Set the required language.
2To set the language, use the icons (B7 and B8) to choose the required language (fig. 2). When the message “PRESS OK TO CHOOSE ENGLISH” is displayed, press the OK icon (B9) (fig. 3) for
3 seconds until “ENGLISH INSTALLED” is displayed. If you set the wrong language, follow the instructions in section ‘Changing and setting menu parameters’, under “Setting the language”. If your language is not available, select one from those displayed. The instructions refer to the English version. Then follow the instructions displayed:
3After 5 seconds, the appliance displays “FILL TANK”. Extract the water tank (fig. 4), rinse and fill with fresh water without exceeding the MAX line. Replace and push as far as it will go. A water softener filter can be installed in the tank (fig. 29).
4Place a cup under the cappuccino maker (fig. 5). The appliance displays: “HOT WATER PRESS OK”. Press the OK icon (B9) (fig. 3) and after a few seconds a little water comes out of the cappuccino maker.
5The machine now displays “TURNING OFF... PLEASE WAIT” and goes off.
6Extract the appliance by pulling it out using the handles (fig. 6). Open the lid and fill the container with coffee beans, then close the lid and push the appliance in.
The coffee maker is now ready for normal use.
Important!
Never introduce
When using the appliance for the first time, you need to make
Each time you turn the coffee maker on by the ON/OFF switch (A23), it performs a SELF- DIAGNOSIS cycle and then goes off. To turn it on again, press the ON/OFF button (A7) (fig. 1)