NEW ZEALAND,
AUSTRALIA and SINGAPORE
INSTALLATION INFORMATION FOR GC600, GC9002, CG901 SERIES* GAS COOKTOPS
IMPORTANT INFORMATION
Read the instructions before installing or using this product.
Please make this information available to the person responsible for installing this cooktop as soon as possible, it could reduce your installation cost.
These products are registered:
in New Zealand at www.ess.govt.nz and in Australia with AGA at www.gas.asn.au.
CAUTION
In order to avoid a hazard these products must be installed according to these instructions for installation.
Please follow installation information carefully. If in doubt consult your local building regulations, local gas authority codes and electrical regulations.
Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.
The product is to be installed only by a person aurthorised to work on gas installations.
WARNINGS
This appliance shall be installed in accordance with the installation requirements of the local gas authority or the appropriate installation code issued by the A.L.P.G.A. and A.G.A. (Reference Code AGA 601), or the Building Authorities requirements.
Particular attention shall be given to the relevant requirements regarding ventilation.
Take care of sharp edges when handling stainless steel products.
When this product is installed it shall not be used as a space heater, especially if installed in boats or caravans.
No combustible material or products should be placed on this product at any time.
Do not spray aerosols in the vicinity of this product while it is in operation.
This product should not be sealed into the bench with silicon or glue. This will make future servicing difficult. Fisher & Paykel will not be liable for costs associated with releasing such a product, nor for repairing damage that may be incurred in doing this.
BEFORE YOU START
DO Prior to installation, ensure that the local distribution conditions (nature of gas and pressure) and the adjustment of the product are compatible.
DO Ensure a suitable disconnection switch is incorporated in the permanent wiring, positioned to comply with the Local Wiring Rules and Regulations.
DO Ensure the benchtop is square and level and ensure no structural members interfere with space requirements.
DO Ensure that there is a 3 pin
DO Make the benchtop of a heat resistant material.
CURRENT INFORMATION
Current Installation Instructions, Product dimensions and specifications are available on the Fisher & Paykel web site.
www.fisherpaykel.com
*Includes Quantum Models
Part No. 530451 D | February 2003 |