Fisher & Paykel GC9002 dimensions DimensionsClearances, Product Dimensions, Cutout Dimensions

DimensionsClearances

PRODUCT DIMENSIONS

	GC600	GC9002	CG901M
Width	578mm	914mm	914mm
Depth	511mm	533mm	546mm
Height	40mm	40mm	76mm

Note Height measurement below bench surface.

CUTOUT DIMENSIONS

		GC600	GC9002	CG901M
A	Width	560-564mm	846-882mm	860-895mm
B	Depth	485-495mm	478-501mm	486-524mm
C	Side Clearances*	140mm	140mm	118mm
D	Rear Clearance*	100mm	100mm	120mm
E	Entry from Side	50mm	50mm	25mm
F	Entry from Back	30mm	30mm	25mm
G	Clearance Below* 60mm		60mm	81mm
	Bench

*Minimum clearance for cutout to combustible surface.

When used with a flexible hose, the connector on the wall should be between 800mm to 850mm above the floor and in the region outside the width of the appliance to a distance of 250mm. This should be accessable with the appliance installed.

RANGEHOOD CLEARANCE (Dimension A)

[See A.G.A. 601 5.12.1.6]

Dimension A (Measured from the plane of the pan supports to Rangehood) should not be less than 650mm.

Any other downward facing combustible surface less than 600mm above the highest part of the hob

shall be protected for the full width and depth of the cooking surface area.

However, in no case should this clearance to any surface be less than 450mm.

SIDE CLEARANCE (Dimensions B & C)

Where Dimension B, measured from the periphery of the nearest burner to any vertical combustible surface, is less than 200mm, the surface shall be protected in accordance with Clause 5.12.1.2 to a Height C of not less than 150mm above the hob for the full dimension (width or depth) of the cooking surface area.

Do use easy-to-clean finishes for the wall surfaces surrounding the cooktop to aid removal of any cooking stains resulting from use of the cooktop.

A.G.A. Clause 5.12.1.2.

A.G.A. Clause 5.12.1.2. Protection of a Combustible Surface Near a Cooking Appliance.

The protection required by clause 5.12.1.1. shall ensure the surface temperature of the combustible surface does not exceed 50°C above ambient.

Note The fixing of 5mm thick ceramic tiles to the surface or attaching fire resistant materials to the surface and covering with sheet metal with a minimum thickness of 1.4mm would satisfy this requirement.

CLAMPING DOWN THE COOKTOP/HOB

Place the cooktop into the cutout and tighten it with the supplied clamps. DO NOT OVER TIGHTEN.

The clamps will cope with bench thickness 15-50mm (see diagram) when used in the two orientations.