CHANGING PRE-SET OPTIONS
OPTION ADJUSTMENT MODE
After using your Smart Drive you may want to change some of the
You can change the following
•the rinse option on Heavy Duty, Regular and Wool cycles
•the amount of water used in the Water Saver option
•the number of beeps at the end of the cycle
•the Out of Balance recovery routine
•the fill level selected by auto water level
To make these changes it is necessary to enter the “Option Adjustment Mode”.
TO ENTER OPTION ADJUSTMENT MODE
1. Plug the machine in, but do not press POWER. Press START / PAUSE and hold down.
Press POWER.
2. When the buttons have been pressed correctly the machine will give two quick beeps and show an unusual pattern of lights.
In this mode the lights are used to indicate the different options available. The diagram on page 24 shows how the lights relate to the options you can change.
Pages 25 - 27 explain the different options in more detail.
3.Use the buttons on the panel to make your changes to the
4.Press POWER to return to normal mode.
5.Your Smart Drive will automatically remember your changes.
6.To make further changes, repeat the above steps.
23
