Manuals / Fisher & Paykel / Kitchen Appliance / Oven

Fisher & Paykel OB60S manual Care and cleaning, To remove a side rack and catalytic panel

Models: OB60S

1 32

Download 32 pages 2.16 Kb

Page 24

To remove a side rack and catalytic panel

22

Care and cleaning

Removing and refitting the side racks (and catalytic panels if installed)

Important!

Catalytic panels are not supplied with oven, but can be purchased optionally. Contact your Elba dealer or visit our local website listed at the end of this document.

Fixing screw

Fig.10 Side rack and catalytic panel in oven cavity

To remove a side rack and catalytic panel

1For easier access to the fixing screws, we recommend removing the oven door first. See ‘Removing and refitting the oven door.’

2Using a small coin or a flat-head screwdriver, loosen and remove the front and back fixing screws, as shown.

3Remove the side rack.

Once you have removed a side rack, the catalytic panel behind it (if fitted) will also be released.

To refit a side rack and catalytic panel

1If the oven has catalytic panels, align a panel with the fixing screw holes and hold it in place, making sure that:

the arrow on the panel is pointing up

2Loosely screw in the the back fixing screw.

3Position the side rack. Make sure it is the right way up, as shown.

4 Loosely screw in the front fixing screw.

5 Check that both fixing screws are straight, then tighten them. 6 If you removed the door, refit it.

Image 24

Fisher & Paykel OB60S manual Care and cleaning, To remove a side rack and catalytic panel

Contents

User guide Built-in ovenNZ AU OB60S modelsPage Contents SAVE THESE INSTRUCTIONSSafety and warnings Failure to follow this advice could result in burns and scaldsElectrical Shock Hazard Failure to do so may result in death or electrical shockImportant safety instructions Safety and warningsHousehold appliances are not intended to be played with by children Always keep oven vents unobstructedPage Oven controls and setting manual mode To set manual modeTo set cooking with auto-off 6 Oven controls and setting the clock Cooking indicator Automatic Cooking indicator Timer indicatorClock Display Temperature knobOven controls and setting the clock Touch controlsIf the display shows It means that8 First use 1 Control panel and knobs 2 Side rack 3 Grill tray5 Flat oven shelf 6 Rubber seal Not illustratedFirst use Using your oven When you have finished cookingDuring cooking Oven functions OVEN LAMPBAKE GRILL12 Using the electronic timer The timer does not turn the oven offUsing the electronic timer To change the Timer VolumeTo select a volume 14 Cooking with auto-off When auto-off is setWhen the cooking time is over The oven will NOT beep or ring when the set cooking time has elapsedCooking with auto-off To set the oven for automatic cooking16 Cooking with auto-off 6 When the stop time is reachedTo Cancel Auto -off Baking charts BAKEFood Time minsFAN BAKE FAN FORCEDBaking charts FoodCare and cleaning What?How? General adviceCare and cleaning visible when the slides areWhat? How?Care and cleaning Removing and refitting the oven doorTo remove the door 1 Open the door fully 3 Hold the door 2 Open the leversCare and cleaning To remove a side rack and catalytic panelTo refit a side rack and catalytic panel Care and cleaning The sliding supports can only be used on shelf positions 1,2 andCare and cleaning Disconnect the oven from the power supply before continuing2 Important Replacing the oven light bulbCare and cleaning Cleaning the door glassTo remove the inner pane and clean the glass The outer pane is not removable Take care, the glass pane is heavy26 Care and cleaning To refit the inner paneLever Troubleshooting Models with electronicWarranty and service Before you call for service or assistancePage NZ AU F&P PN - 590496 A F&P ITALY PN - 1104143-ß110.2012 Copyright Fisher & Paykel 2012. All rights reserved