PREPARING THE OVEN

UNPACKING THE OVEN

Do not use door handles or any part of the control panel for lifting the product. Before the product is lifted, the oven doors and racks are to be removed.

WARNING : Extreme care is to be taken when lifting the product as it is very heavy. Failure to do so may result in injury.

1.Carefully lay the product on its back. Remove the external wrapping and the bottom polystyrene protector and pallet. Stand the product up and remove all other polystyrene packaging.

2.Remove the oven doors. This is done by:

Open the oven door fully.

Lift the catches on both of the hinges over towards you onto the hooks of the hinge arm (see picture below).

Raise the door slightly, holding on either side near the handle, making sure that the clips stay on the hooks.

WARNING : Do not lift the door out by the handle as this may cause damage to the product.

Lift the door out.

Door Hinge

 

Hook

 

Clip

 

Door

WARNING : Do not disengage the hinge hooks when the door has been removed as they are differcult to re-engage.

3.Remove the wire shelves and oven trays by sliding them out. Use both hands to remove each item. Remove the cardboard packaging from the oven cavity.

PAGE 5 OF 8

FLUSH FITTING INSTALLATION OPTIONS

a

20 mm

2.5 mm

b

20 mm

2.5 mm

CUPBOARD FRONT

c

20 mm

2.5 mm

DRAWER FRONT

Page 5
Image 5
Fisher & Paykel OD301 warranty Preparing the Oven, Unpacking the Oven