ATTACHMENT
PAGE 7 OF 8
WARNING : Extreme care is to be taken when lifting the product as it is very heavy. Failure to do so may result in injury.
1.Slide the product into the oven cabinet, pushing the product between the two oven cavities or by the edges of the oven cavity.
If the product does not sit flush with the front of the oven cabinet, make certain that the electrical supply cable has not jammed behind the product. Ensure the bottom vent is not blocked off or damaged.
screw | screw | screw |
|
|
2.Securely fasten the oven to the cabinet using the screws provided. Insert the screws through the holes in the side extrusions and through the spacers placed between the side extrusion and the kitchen joinery (see diagram opposite).
Do not over tighten screws.
3.Replace the oven trays and wire shelves. The shelves have a
front and back. Insert them into the oven in the correct way to ensure that the
4. Refit the oven doors. This is done by:
Place both upper hinge arms in the top slots and both lower hinge arms in the lower slots.
Push the hinges as far as they will go until the slot in the lower arm locates in the hinge support.
Lower the door gently. Push the catches away from you off the hooks. Make sure that they disengage properly.
Raise the door slightly and ensure the catches are released from the hooks. The door can now be closed.
