Fisher & Paykel OR61 manual Installation instructions, Installing your cooker, Anti-tip brackets


NN $-&"3"/$&


NN $-&"3"/$&

2

Installation instructions

Installing your cooker

Connection of this cooker to fixed or flexible wiring must be made by a suitably registered

person. Connection by an unregistered person can cause a safety hazard.

We recommend that the cooker circuit is protected by a suitably rated circuit breaker but not connected to a Residual Current Device (R.C.D.) or an Earth Leakage Circuit Breaker (E.L.C.B.).

This cooker is designed for a 230/240V AC single

or two phase connection. This cooker must be connected with an

appropriately rated cord and plug that is

compatible with the socket-outlet fitted to the final subcircuit in the fixed wiring that is intended to supply this cooker. For single phase connection, the supply cord should be at least equivalent to an ordinary PVC sheathed and insulated, 4 mm2, three-core (twin and earth), flexible cord. For two phase connection, the supply cord should be at least equivalent to an ordinary PVC sheathed and insulated, 2.5 mm2, four-core, flexible cord.

This appliance must be connected to a circuit which incorporates an isolating switch providing full disconnection from the power supply.

Cabinet clearances are as in the diagram on the right.

If you raise the cooker to align it with the bench, make sure the base of the cooker cannot slip.

Anti-tip brackets

Two anti-tip brackets are supplied with the accessories so that the cooker can be secured to the wall to prevent it from tipping over. Use the two screws on the back panel of the cooker, shown below.

WARNING!

Tipping Hazard

All cookers can tip. Keep children away and take care.

The anti-tip brackets supplied must be installed.

Failure to follow these instructions could result in injury.

ANTI TIP BRACKET