US 8 Installation instructions
CA
4. Installation
Your Fisher & Paykel ActiveSmart™ refrigerator is fitted with front and rear rollers, designed for moving the product in the forwards and backwards direction.
Avoid moving the product in a sideways direction as this may damage the rollers or the floor covering/surface.
A Your refrigerator will arrive with the front feet wound |
Lower the front of the refrigerator
Raise the front of the refrigerator
| up making moving the product into its final location |
| a simple task. |
B | Roll the refrigerator into its final position making sure |
| there is the correct air gap between the product and |
| surrounding cabinetry. See minimum clearance in |
| cabinetry dimensions table (refer to page 7). |
| (French Door models only) |
C | Adjust the front feet down until the refrigerator |
| is leaning backward with the front approximately |
| 3/8” (10 mm) higher than the back. This will ensure |
| a good door closing action (refer to Fig.2). |
D | Aligning your refrigerator with cabinetry. |
■■Align the sides of the refrigerator with the cabinetry by adjusting the hinge side front foot.
■■Adjust the handle side foot until it touches the floor and takes a small amount of weight.
■■Once the refrigerator is in place and aligned with cupboards/alcove, push gently on the front top and check if the product is rocking or stable.
5.Leveling of refrigerator door (French door models only)
■■For uneven surfaces, front feet can be used to align the
2doors.
■■If left hand door is too low, then unscrew the left hand foot to lift up the cabinet until the two doors top edges are aligned.
■■If right hand door is too low, then adjust the right hand foot in the same way.