SC4H/UF
ALTERNATIVE CABLE TV CONNECTIONS
Cable converter/decoder output channel setup
1Be sure the cable connections are correct. (See page 11.)
2Turn on the TV, VCR and cable converter/decoder.
3Set the TV to channel 3 or 4.
4Press the VCR button on the remote control to select the VCR operation mode.
5If the VCR indicator is off, press the TV/VCR button on the remote control.
The VCR indicator lights.
NOTE: If the initial setup has not yet been completed, the “Auto Setup” and “RF Channel Setting Ch03 (or RF Channel Setting Ch04)” message will appear. In that case, first follow steps 5 – 7 under “INITIAL SETUP” on page 14.
6Press the MENU button on the remote control. The main MENU appears.
@@@@@@@@@MENU
Timer@program
VCR@setup
Clock@set
Language@select
Rec.List@super
Auto@tuning@memory
[ùû]†Select [OK]†Set@@@@@@[MENU]†TV
7Press the ù (or û) button to select the VCR setup option, then press the OK button.
The VCR setup menu appears.
CATV/TV@@@@@@@zCATV@TV
Cable@box@@@@@zNo@@@Ch02
MTS@@@@@@@@@zST@SAP@Mono
Audio@out@@@zST@L@R@Mono
Child@Lock@@@@@On@@zOff
Off@timer@@@zOff@2Hr@6Hr
Auto@AV@Select@On@@zOff
[ùû]†Option [<>]†Select@@@[MENU]†TV
8Press the ù (or û) button to select the Cable box option.
9Press the > (or <) button to set your cable converter/decoder output channel. The output channel should be indicated on the cable converter/decoder back panel. If not, please refer to the cable converter/decoder instruction manual for details.
Press the > (or <) button repeatedly. Each time you press the button, the selection changes:
No Ch02 Ch03 ... Ch07
The selection is indicated by the “ z” next to it.
NOTE: Select “No” if you are not using the cable box.
FWhen finished, press the MENU button to exit the menu display.
IMPORTANT NOTES:
When the cable converter/decoder output channel is selected as described above,
œThe VCR tuner remains set to receive the same channel as the output channel of the cable converter/decoder. Auto channel programming and manual channel selection using the VCR tuner are not possible.
œIf you turn on the cable converter/decoder after turning on the VCR, no image will appear on the TV screen. In this case, turn off the VCR, then turn it on again.
œLeave the cable converter/decoder on until timer recording is complete.
œFor timer recordings, you must select the channel to be recorded using the channel selector on the cable converter/decoder.
12
