SC4H/UF
MULTIBRAND UNIVERSAL REMOTE CONTROL
Battery Installation and Operation
1Install the two supplied AA batteries as shown.
2Aim the remote control at the VCR and press the desired buttons to operate.
Setting the remote control code
The multibrand universal remote control can operate the basic functions of TVs and cable (CATV) converters/decoders made by the manufacturers listed below.
To enter the remote control code for your brand of TV or cable converter/decoder, follow the steps below.
For TV operation
1In the chart below, find the code corresponding to your brand of TV.
2While holding down the TV button, enter the
The remote control is now set to operate your TV.
IMPORTANT NOTE:
SPENT OR DISCHARGED BATTERIES MUST BE RECYCLED OR DISPOSED OF IN A SAFE MANNER IN COMPLIANCE WITH ALL APPLICABLE LAWS.
FOR DETAILED INFORMATION, CONTACT YOUR LOCAL COUNTY SOLID WASTE AUTHORITY.
Using the remote control
1Before using the remote control, press the VCR, TV or CATV/DSS button to select the device to be operated.
2To switch the remote control mode (to operate a different device), be sure to press the VCR, TV or CATV/DSS button first.
NOTES:
œThe remote control will not operate properly if something comes between the VCR and the remote control.
œThe POWER, 0 – 9, 100/ENTER, INPUT and CH/TRACK l and j buttons are used to operate the VCR, TV, cable box and DSS receiver.
œVOLUME buttons operate TV volume regardless of the remote control mode selected.
TV brands | Code |
ADMIRAL | 05, 10, 13 |
EMERSON | 17 |
FISHER | 03 |
GE | 07 |
GOLDSTAR | 01 |
HITACHI | 02 |
JVC | 15 |
MAGNAVOX | 08 |
MATSUSHITA | 12, 18 |
MITSUBISHI | 14 |
PANASONIC | 12, 18 |
QUASAR | 12, 18 |
RCA | 06 |
SAMSUNG | 16 |
SANYO | 03 |
SHARP | 00, 13 |
SONY | 11 |
TECHNOL ACE | 05 |
TOSHIBA | 04 |
ZENITH | 09, 10 |
|
|
NOTE: There may be some older TV models that cannot be operated with this remote control. If this is the case, use the original remote control supplied with the TV.
8
