![](/images/new-backgrounds/1191485/19148513x1.webp)
LENS REPLACEMENT AND INSTALLATION PROCEDURE
Perform the steps
1
to
5
for lens replacement and installation.
UPPER LENS COVER |
| C |
|
|
|
1
REMOVE THE LENS COVER. (See
1. Remove screws A (2 screws).
2. Pull down the lower lens cover while pushing the part D, then remove it.
3. Remove screws B (2 screws).
4. Remove screws C (2 screws) and remove upper lens cover.
B
D
2 |
| D |
|
● IN CASE OF MODEL WITHOUT LENS | A |
| LOWER LENS COVER |
REMOVE THE COVER PLATE OF THE LENS COVER. (See
Remove 2 screws and pull down the plate.
(At the step 4 , insert the
Set the
SCREWS
COVER PLATE
Fig-2
●IN CASE OF MODEL WITH LENS
❋ Figure shown inside of the cabinet. | LENS MOTOR |
(D)(D)
REMOVE THE LENS. (See
1.Remove the connector “K16B” of the circuit board.
2.Loosen the A, B wire holder and remove the lens motor lead.
3.Remove screws D (4 screws) which fastens the lens and remove the lens.
A
(D)(D)
B
A
LENS
MOTOR LEAD
CONNECTOR “ K16B”