COMPUTER MODE

SELECTING INPUT SOURCE

DIRECT OPERATION

Choose either Input 1 or Input 2 by pressing INPUT button on Top Control or on Remote Control Unit.

 

MENU OPERATION

1

Press MENU button and ON-SCREEN MENU will appear. Press

 

POINT LEFT/RIGHT button to move a red frame pointer to

 

INPUT Menu icon.

2

Press POINT DOWN button to move a red arrow pointer to

 

either Input 1 or Input 2 that you want to choose and then press

SELECT button.

When choosing Input 2, Source Select Menu will appear. Move POINTER to RGB and then press SELECT button. (Input 2 accepts R, G, B, H/V and V computer signals (P 13).)

INPUT button

Input 1

Input 2

Input 3

INPUT MENU

INPUT Menu icon

Move POINTER (red arrow) to Input 1 or 2 and press SELECT button.

INPUT 2

Source Select Menu (Input 2)

Move POINTER to RGB and press SELECT button.

SELECTING COMPUTER SYSTEM

This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to “COMPATIBLE COMPUTER SPECIFICATION” on page 27). When selecting Computer, this projector automatically tunes to incoming signal and projects proper image without any special setting. (Some computers need setting manually.)

Note : Projector may display one of the following messages.

AUTO PC Adj.No signal

When projector cannot recognize connected signal SYSTEM MENU as PC system provided in this projector, Auto PC

Adjustment function operates to adjust projector and the message “AUTO PC Adj.” is displayed on SYSTEM icon. When image is not provided properly, manual adjustment is required. (Refer to P25 and 26.)

There is no signal input from computer. Make sure the connection of computer and projector is set correctly.

(Refer to TROUBLESHOOTING on page 40.)

SYSTEM Menu icon Displays system being selected.

23