APPENDIX

Follow these steps to replace lamp assembly.

1

Turn off a projector and disconnect AC plug. Allow a projector to

 

cool for at least 45 minutes.

2

3

Loosen 2 screws with a screwdriver and open Lamp Cover.

Loosen 2 screws with a screwdriver and pull out Lamp Assembly by grasping Handle.

4

Replace Lamp Assembly with a new one and tighten 2 screws

 

back. Make sure that Lamp Assembly is set properly. Replace

Lamp Cover and tighten 2 screws.

5

6

Connect AC Power Cord to a projector and turn it on.

Reset Lamp Replace Counter (refer to next page “LAMP REPLACE COUNTER” section).

46