L | Caring For |
| Your Scooter |
Tire Valve
•Maximum tire air pressure is 30 lbs.
•Do not over inflate the tires.
•Check all screws, cap nuts and protective coverings regularly and tighten as required. Check plastic parts on a regular basis for cracks or broken pieces.
•During snowy or rainy weather, the scooter should be stored inside or under a protective cover. Remember to charge the battery at least once per month while your scooter is not in regular use.
•Avoid operating the scooter in wet or snowy conditions and do not spray the scooter with a hose. Do not wash the scooter with soap and water. Water or moisture in the motor or electrical switches can cause them to corrode and could cause switch or motor failure. Do not immerse this scooter.
•Avoid operating the scooter on sand, loose dirt or gravel. Sand, loose dirt or gravel in the motors or electrical switches can cause them to jam and could cause switch or motor failure.
•The scooter can be wiped down with a soft, dry cloth. For a shiny finish, you can wipe plastic parts with a
•To ensure that your scooter stays in good operating order, we recommend that you periodically have your scooter checked by a Power Wheels® authorized service center. See page 24 for the list of authorized service centers or call
•Tire repair must be done by a Power Wheels® authorized service center. See page 24 for the list of authorized service centers or call
M | FCC Statement |
(United States Only) |
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.
19
