Assembly
5
Lower
Clamp
Allen
Wrench
7
Brake Handle
•Tighten the nut in the lower clamp with the Allen wrench. Do not
Head Tube 
Fork 
Front 
Wheel
Front of Scooter
6
Brake | Handlebar |
Cable |
Power
Wire
Plastic Tie
Cut off
Excess
Plastic Tie
•Make sure the handlebar is in its highest position.
•Wrap the plastic tie around the brake cable, power wire and the handlebar.
•Insert the flat end of the plastic tie into the opening in the square end of the plastic tie. Pull the flat end of the plastic tie with pliers to be sure it is tight around the handlebar.
•Using safety scissors, cut off the excess plastic tie. Throw the excess plastic tie away.
•Adjust the handlebar so that the brake handle faces the front of the scooter.
•Fit the front wheel onto the head tube so that the fork bends toward the front of the scooter.
8
•Insert a bolt through one side of the fork, handle tube and out through the other side of the fork.
•Turn the front wheel so that it is sideways, as shown.
•Attach the nut to the bolt. While holding the nut with an adjustable wrench, tighten the bolt with the Allen wrench. Do not
IMPORTANT! Assembly is now complete, but you must adjust the brake before first time use. Please proceed to the section Adjusting the Brakes, page 10.
9
