Assembly
5 | Rear Axle |
| Motor Assembly Pins |
| Rear Axle Assembly |
Rear Wheel Driver |
|
•Position the vehicle body upright.
•Fit and hold a rear wheel driver against the motor pins on one end of the motor assembly.
•While holding the rear wheel driver in place, slide the rear axle into the hole in the opposite side of the motor assembly. Make sure the rear wheel driver on the rear axle assembly fits onto the pins on the motor assembly.
•Take the rear wheel driver off the open end of the rear axle.
6 |
|
|
Hubcap | Hex |
|
Bushing |
| |
|
| |
Cap Nut |
|
|
Cap Nut |
|
|
Assembly Tool | Rear | Washer |
| ||
| Wheel Driver |
|
•Slide a wheel onto the rear axle. Make sure the ribs on the wheel fit into the grooves on the rear wheel driver.
•Slide a hex bushing, barrel side first, onto the rear axle. Press all but the ring on the hex bushing into the wheel.
•Slide a hubcap onto the rear axle.
•Fit a cap nut on the end of the rear axle.
•Fit the cupped end of the cap nut assembly tool over the cap nut and tap the end of the cap nut assembly tool with a hammer to secure the cap nut on the end of the rear axle.
7 |
|
|
| Hubcap | Washer |
|
| |
Cap Nut |
| Round |
| Bushing | |
Assembly |
| |
|
| |
Tool |
| Wheel |
|
| |
|
| Hex Bushing |
| Cap Nut |
|
•Slide a washer onto one of the front axles.
•Slide a round bushing, ring side first, onto the same front axle.
•Slide a wheel (ribbed side first) onto the front axle.
•Slide a hex bushing onto the front axle. Press all but the ring on the hex bushing into the wheel.
•Slide a hubcap onto the front axle.
•Fit a cap nut on the end of the front axle.
•Fit the cupped end of the cap nut assemby tool over the cap nut and tap the end of the cap nut assembly tool with a hammer to secure the cap nut on the end of the axle.
•Repeat this procedure to assemble the remaining wheel to the other front axle.
Helpful Hint: You may want the help of another adult to support the assembled end of the rear axle to complete rear axle assembly.
•Slide a washer onto the rear axle.
•Slide the rear wheel driver onto the rear axle. Make sure the rear wheel driver fits onto the pins on the
motor assembly. | 10 |
|
