|
|
TypeLATCH Installation
Figure 1 illustrates a typical forward-facing LATCH installation.
warning
Always use in upright position in forward-facing mode. See page 11.
important! Verify that your vehicle is equipped with lower anchors. If lower anchors are not installed, you must use vehicle belt installation methods (see pages
1. Lift up cover from seat and remove the lower |
hook strap and lower hooks out of the |
belt path OR from the storage slots (Fig. 2). Pull |
hooks through |
2. Press and hold the lower adjuster release |
1
1
5. Kneel on the restraint to push it into the vehicle seat while pulling the lower hook strap tight (Fig. 5).
6. Install tether as instructed on pages
7. Verify that all connections are secure and the restraint is stable. A secure restraint should allow no more than 1 inch of
LATCH Removal
5
button, then pull to lengthen lower hook strap |
to full length. |
3. Verify that the lower hook strap is not twisted, |
then attach the left lower hook to left lower |
anchor in desired seating position (Fig. 4). |
Pull on lower hook to confirm attachment to |
lower anchor. |
4. Verify that the lower hook strap is not twisted, |
then attach the right lower hook to right lower |
anchor in desired seating position. Pull on |
lower hook to confirm attachment to lower |
anchor. |
2 | 3 | 1. | Press button on lower adjuster to loosen lower | |
|
|
| hook strap (Fig. 6). | |
|
| 2. | Press on tab to release hook from lower anchor. | |
|
| 3. | Disconnect the tether. | |
|
|
| IMPORTANT! | When not in use, always |
|
|
| store the lower hooks in storage slots under | |
|
|
| cover (see page 16, Fig 2). | |
4a
4
6
24 | 25 |
