Assembly
Motorized Frame
L
R | Tube |
|
Elbow Foot | Button |
|
5 | Red Dot | Hole |
|
•Locate the R and L on the underside of each elbow foot. The R indicates the right leg. The L indicates the left leg.
•While pressing the upper button on the right leg, fit it into the tube in the motorized frame. Make sure the upper button on the right leg “snaps” into the hole in the tube.
•Repeat this procedure to assemble the left leg to the motorized frame.
•When the legs are assembled correctly to the tubes in the motorized frame, you should not see the red dots.
Ruffle
Seat
Slot
Crotch Belt
7
•Position the seat upright.
•Place the pad onto the seat with the ruffle toward the top of the seat.
•Fold the bottom of the pad up. Insert the crotch belt through the slot in the pad. Make sure the crotch belt is not twisted.
ButtonButton
| Feet | Feet |
6 | L | R |
•Stand the assembly upright.
•Pull the legs out so that the buttons “snap” into the holes in the motorized frame.
•When standing behind the product, all four feet should be flat upon the floor. And, check for an L marking on the left foot and an R marking on the right foot.
•If the feet are not flat upon the floor, or the left and right feet have been reversed, remove both lower legs from the upper legs. Replace them onto the opposite upper leg.
Hole
Hole
Elastic | Peg |
Loops |
|
Elastic
Loops
8
Bottom View
•Fold the top of the pad down.
•Insert the two elastic loops on the pad through the holes in the seat bottom.
•While holding the elastic loops in place, turn the seat face down.
•Hook the elastic loop on the left side onto the peg on the right side.
•Hook the elastic loop on the right side onto the peg on the left side.
Hint: The elastic loops should cross over each other when attached correctly to the pegs.
5
