ASSEMBLYF
ASpacers
16 | B #8 x 4" Screws |
• Fit the spacers between the upper holes of the brush guard and the front end of the vehicle A .
•Insert two #8 x 4" screws through the two upper holes in the brush guard, through the spacers and into the front end of the vehicle B . Tighten the screws.
Holder
18 |
•Fit the holder to the top edge of the vehicle as shown.
•Insert a #10 x 1" screw into the holder and tighten.
•Replace Backpack in the holder.
Backpack
17 |
•Using safety scissors, cut the plastic tie holding Backpack in the holder. Remove Backpack from the holder.
Note to Retailer: Do not remove the plastic tie. Simply lift Backpack from the holder and assemble the holder to the top edge of the vehicle. Replace Backpack in the holder.
13 |
