Fisher-Price R1502 owner manual Motor Assembly Hubcap Washer Rear Axle Lock Nut, Assembly Wrench

ASSEMBLY

Motor Assembly

7/16" Hubcap

Washer

Rear Axle

Lock Nut 7/16" Washer

Rear Wheel

Driver

4

•Slide a 7/16" washer onto the rear axle.

•Slide the rear wheel driver onto the rear axle. Make sure the rear wheel driver fits onto the pins in the motor assembly.

•Slide a wheel onto the rear axle. Make sure the ribs on the wheel fit into the grooves on the rear wheel driver.

•Slide a hubcap, indented side out, onto the rear axle.

•Slide a 7/16" washer onto the rear axle.

•Fit a 3/16" -16 lock nut on the end of the rear axle and hand tighten.

Assembly

Wrench

5 Rear Wheel

•Completely tighten the lock nuts on both sides of the rear wheel assembly with the assembly wrenches.

Hint: An extra wrench has been provided to hold the lock nut on one side of the rear axle while tightening the lock nut on the other side.

Hub Cap

Cover

6

• Fit a hub cap cover onto each rear wheel and push to "snap" in place.

Ring End

Wheel	Front Axle
	7/16"
Hubcap	Washer
7/16"	Round
Washer
	Bushing

Lock Nut

Assembly

Wrench

7

•Remove the protective caps from each front axle and throw them away.

•Slide a 7/16" washer onto one of the front axles.

•Slide a round bushing, ring end first, onto the front axle.

•Slide a wheel (ribbed side first) onto the front axle.

•Slide a hubcap (indented side out) onto the front axle.

•Slide a 7/16" washer onto the front axle.

•Fit a 3/8" -16 lock nut on the end of the front axle and tighten with the assembly wrench.

•Repeat this procedure to assemble the remaining 7/16" washers, round bushing, wheel, hubcap and 3/8" -16 lock nut to the other front axle.

Hub Cap Cover

8

•Fit a hub cap cover onto each front wheel and push to "snap" in place.

10 R1502a-0920