ASSEMBLY
Some components can be removed to allow the cabinet to pass through short or narrow doorways.
The door handle can be removed as follows:
1.Remove the screw and bolt from the tumbler.
2.Remove the two mounting screws and the handle assembly (Fig. 1)
| MOUNTING SCREW | |
ASSEMBLY | HANDLE ASSEMBLY | |
MOUNTING | ||
SCREW |
| |
SCREW |
| |
BOLT | PLUG | |
BUTTON | ||
| ||
DOOR | ||
| KEY |
3.Replace in reverse order of disassembly. Door(s) and hinges can be removed as follows:
1.Lift up and remove the front trim panel (Fig. 1).
Fig. 1
UPPER HINGE
2.Remove the screws which secure the trim rail cover (Fig. 1), unplug the door switch lead wires, and remove the screws which secure the trim rail (Fig. 1). Carefully lay the trim rail on top of the cabinet — avoid damaging or kinking the thermometer capillary tube.
3.Remove the three screws which secure the upper hinge plate to the cabinet (Fig. 2). This will remove hinge tension. Remove the nut underneath the lower hinge plate which secures the bottom hinge. Remove door. Remove lower hinge plate (Fig. 2).
FRONT TRIM PANEL
TRIM RAIL COVER
P L - 5 3 6 1 5
Fig. 2
TRIM RAIL
LOWER
HINGE
SCREWS
(3)
Fig. 3
4.If the hinge mechanism should become uncocked while changing the door, it will be necessary to recock the hinge mechanism. To do this, remove the door from the cabinet and position the door face down on a workbench or table. Using a 5/16" open end or adjustable wrench, turn the hinge mechanism shaft 135° (Fig. 3).
5.Replace the hinge plates and door(s) in the reverse order of disassembly.
If cabinets are too tall, the refrigeration system may need to be removed in order to pass through short openings. Contact your dealer or authorized servicer if this becomes necessary.
UNCOCKED POSITION | COCKED POSITION |
TURN 135 º | 135 º |
–POSITION 1 – (LEFT - HAND HINGED DOOR)
UNCOCKED POSITION | COCKED POSITION |
TURN 135 º | 135 º |
– POSITION 2 – (RIGHT - HAND HINGED DOOR) POSITION DOOR IN ONE OF THE TWO POSITIONS SHOWN .
Fig. 4
Once the cabinet is in its final position, replace any components that may have been removed (door handle, etc.) and then level the cabinet
Door Hinging
Should the doors need to be rehinged (from right to left or vice versa), contact a
– 3 –