Assembly
Support Wall
Track
1 | BOTTOM VIEW |
•Fit the support wall into the sockets in the track, as shown. Push to “snap” in place. Hint: The support wall is designed to fit into the slots one way. If it does not seem to fit, turn it around and try again!
3 Gray Supports
2
•Fit three the gray supports into the sockets in the bottom of the track. Push to “snap” each in place. Hint: The supports are designed to fit into the sockets one way. If a support does not seem to fit, try fitting it into a different socket!
3 | Base |
•Turn the track assembly upright.
•Fit the support wall on the track assembly into the sockets in the base, as shown.
•Push to “snap” in place.
5
