Assembly
Elevator Walls
Elevator Floor
10
• Fit two elevator walls into the slots in an elevator fl oor.
Hint: The elevator walls are designed to fit into the elevator floor one way. If they do not seem to fit, turn them over and try again!
• Push to “snap” each in place.
Elevator Roof
11
•Fit an elevator roof onto the elevator walls. Push near each of the four corners to “snap” in place.
Hint: The elevator roof is designed to fit onto the walls one way. If it does not seem to fit, turn it around and try again!
•Repeat this procedure to assemble the other elevator.
Pegs
12 | Elevator |
•Fit the center pegs on the elevator crane into the grooves in an elevator. Push to “snap” the elevator in place.
Hint: The elevator is designed to fit on the elevator crane one way. If it does not seem to fit, turn it around and try again!
8
