Glossary
DISPENSE RATE | Always start with the slowest recommended rate and increase |
| incrementally. |
DRAWBACK DELAY | When using a small needle you can take advantage of the |
| drawback delay feature to give you more control over your output |
| volume. This feature allows the fluid to flow out of the syringe |
| before you drawback the PosiLokTM piston and begin your next |
| dispense cycle. |
FACTORY SETTINGS | The factory settings will be replaced with your settings when you |
| save into location #1 and #2 |
SAVE | When you save an application into a location that has a |
| previously stored application, you will be asked to replace the |
| existing application. |
RESTORE | When you restore an application from a location, the parameters |
| will flash on the display. You will then be asked to restore the |
| application. |
ACTIVATING |
|
A PARAMETER | if you notice that a parameter that you set didn’t take effect, |
| make sure you pressed the ENTER key before proceeding to the |
| next screen. If you did not press the ENTER key, the values you |
| entered will not take effect on the next dispensing cycle. |
NEEDLE SELECTION | When selecting a needle we recommend using the FreeFlowTM tip |
| with the LDS9000. This tip allows the least amount of flow |
| restriction thus allowing positive flow of the fluid from the |
| syringe. |
PREPACKAGED |
|
SYRINGE | Must be free of air pockets to receive the full benefits of the |
| LDS9000. Contact your Fishman representative for AirFreeTM |
| filling suggestions. |
29
